sim rich

Completed

Sailor 1000 system receiver power supply tested.

Sailor1000 description and plans for making a stand alone powersupply.

Marconi CR100 Renovation (55) Main case installed.

Marconi CR100 Renovation (54) Case repainting

Marconi CR100 Renovation (53) Ready for the case.

Marconi CR100 Renovation (52) A tune around the bands and look at the front panel.

Marconi CR100 Renovation (51) 100hz band pass filter aligment

Marconi CR100 Renovation (50) Aerial and HF coils alignment.

Marconi CR100 Renovation (49) Oscillator coil alignment.

Marconi CR100 Renovation (48) Part 2 of the band change drum cord.

Marconi CR100 Renovation (47) Band change drum cord fitting part 1.

Marconi CR100 Renovation (46) Replacing the tuning scale cord.

Marconi CR100 Renovation (45) If alignment update

Marconi CR100 Renovation (44) IF amplifier alignment.

Marconi CR100 Renovation (43) A few of the niggly problems repaired .

Marconi CR100 Renovation (42) First power.

Marconi CR100 Renovation (41) Resistance checks and applying mains voltage.

Marconi CR100 Renovation (40) Coil pack problems.

Marconi CR100 Renovation (39) Coil pack refitting.

Marconi CR100 Renovation (38) Terminal block and band switch cord.

Marconi CR100 Renovation (37) Mains transformer and mains socket installed.

Marconi CR100 Renovation. (36) Main oscillator capacitor check.

Marconi CR100 Renovation (35) IF board completed and start on the RF board

Marconi Cr100 Renovation (34) IF Transformer installation.

Marconi CR100 Renovation (33) Clean and test the volume control.

Marconi CR100 Renovation (32) Crystal filter checking

Marconi CR100 Renovation (31) If strip installed. a look at the next part to complete.

Marconi CR100 Renovation (30) Installing the IF tag strip

Marconi CR100 Renovation (29) wiring up around V10 and V8