Richard Wallace
I’m an IT professional, based in Cardiff, UK, with a keen interest in bbq, flying, motor sport, Electric Vehicles (EV), 3D printing and all things technology
Bambu Lab Support for PLA
How Much Does It Cost to Run a Bambu Lab H2D? Power Consumption Tested!
VW ID.7 Dynamic Matrix LED Headlights and Heads Up Display (HUD)
VW ID.7 Tourer IQ.Light Animations
Bambu Lab A1 Electricity Costs
Bambu Lab X1 Carbon Electricity Costs
Printing a Pit Droid on the Bambu Lab X1 Carbon
Bambu Lab A1 environment temperature and fumes
Pooping good benefit of the Bambu Lab A1 over the X1 Carbon
Printing a Lego Skeleton on the Bambu Lab A1 and X1 Carbon
I bought a new 3D printer - Bambu Lab A1
Sunlu FilaDryer S4 #sunlu #filament #dryer
Mercia Elite 4m x 3m Log Cabin and Shed Build in the UK
Bambu Lab X1 Carbon Noise Test
How to enable Apple Intelligence in iOS 18.1 beta when outside of the US
Škoda Enyaq Adaptive Cruise Control and Travel Assist
Bambu Lab X1 Carbon just got quieter
Bambu Handy - Differences when using with Bambu Lab X1 Carbon and A1 Mini
Making the Bambu Lab X1 Carbon a bit quieter
Remote printing on the Bambu Lab X1 Carbon via the Bambu Handy iOS app
iPhone 15 Pro stuck on software update during setup
Škoda Enyaq iV tips: You don’t need to use the start/stop button or the handbrake
Masterbuilt Gravity Series 800 wouldn’t go above 170C until I did this #masterbuilt #bbq #smoker
How long does it take the Masterbuilt Gravity Series 800 to go from 200C to 350C?