Ali
I break stuff so you don't need to.
How to read the CAN BUS using SavvyCAN with an ESP32
DIY EV Part 56 - Installing the Nissan Leaf BMS in the eGolf pack
DIY EV Part 55 - Another addition to the Shelf of Shame!
DIY EV Part 54 - Tidying up the Low Voltage Junction Box.
DIY EV Part 53 - Installing the Heater and Cleaning the Hoses, on the inside???
DIY EV Part 52 - Testing the Replacement Cabin Heater.
DIY EV Part 51 - Fixing Some of the Bits I Broke!!!
DIY EV Part 50 - Steering a new course with a Volvo PAS Pump
DIY EV Part 49 - Installing an Android Head Unit in a Freelander EV
DIY EV Part 48 - Driving to the MOT Centre.
DIY EV Part 47 - Getting it ready for MOT and First Drive on the Road 😃
Электромобиль своими руками, часть 46 — операция на открытом сердце с инвертором 😮
Bob and Brad Q2 Mini Massage Gun review
DIY EV Part 45 - Plumbing, Batteries and a Little Bit of Fire.
DIY EV Part 44 - Plumbing and Cabling front to Back?
DIY EV Part 43 - Fuel Tank Battery Box Installed at last.
DIY EV Part 42 - More BMS Wiring
DIY EV Part 41 - Fish tank Battery Box
DIY EV Power Steering Using a Car Alternator Part 2 - A wee update.
DIY EV Part 40 - Installing batteries for real this time!
DIY EV Part 39 - Preparing the 'Good' car for Electrification.
DIY EV Part 38 - Weighing the car before and after Conversion
ESP32 Broadcasting Temperature on WiFi Optimised by ChatGPT
Mercedes Rear Brakes, Disks, Pads AND Shoes
DIY EV Part 36 - Connecting up the HV Junction Box Plus a VERY quiet test run.
DIY EV Part 35 - Rear battery box in the Boot/Trunk
Fitting a wheel stud without taking the hub apart
DIY EV Part 34 - 12V Battery Tray
DIY EV Part 33 - Rear Lower Battery Box