Creating Stuff With Jim
The purpose of my channel is to share thing I build in my shop from day to day. I also want to pass on knowledge I have learned and experiences I have had. Finally if I can inspire someone to learn a new skill or tackle a project I will truly feel successfull.
Patching the hole in the transmission tunnel on the inferno build
Warn 8274 winch repair
3.4l Toyota V6 Mounting a York air compressor
Working on a antique fire truck part2
Working on an antique fire truck Part 1.
Building a custom tool box organizer
Rad Design rail controller install
Bridgeport series 1. New to me tool review.
Tacoma cruise control hack. Making an electronic remote throttle.
FJ40 walk around and story of the born again cruiser
Unfortunately no video this week. I do want to thank everyone who watches my videos.
The first test drive of the inferno truck build
Installing a compete brake system on the inferno build.
Installing a custom Driveline in the Inferno project
3.4l Toyota V6 swap Making the engine run!!!! Inferno Build
Hydraulic flaring tool review. Show and Tell
Installing the fuel tank into the inferno truck build
How to remove dump bed insert.
Figuring out what springs to put underneath the Inferno truck build.
Palomino 1240ss Truck camper modifications.
Building shock towers for the Inferno truck build
York air compressor on a Toyota
Building a 3 link rear suspension. Project Inferno episode 14
MGB fuel injection conversion. First start and test drive.
MGB fuel injection conversion. New fuel system and electrical system Installation.
MGB Fuel Injection. Solving the problem of installing an addition temperature sensor.
MGB Fuel Injection. Designing the Adapter plate to mount the Sniper throttle body to the MG engine.
MGB fuel injection conversion Introduction.
Putting the Finishing touches on the tilting trailer.
Making fork mounts for an equipment trailer.