Caverntwo
Hello World!
I'm a game/software/web dev from Austria. On this channel, you see what I do in my free time!
I started this channel focusing only on 3d-printing in 2017 when I was still in high school. As I grew up, my life changed too, and so did my interests. Because of that, nowadays, 3d printing is a tool to create stuff, and not the main focus.
Be ready for the unexpected. There might be videos about software development, 3d designing / 3d printing, as well as building, designing, fixing, and restoring electronics, cars, and even buildings.
I share content in the hope that it is helpful. I'm no professional in any way and therefore cannot be held responsible for the correctness and anything going wrong on your side. You use my content at your own risk!
For questions, leave a comment or contact me directly!
Thanks
Marlin 2.0 – Power Loss Recovery
Installing Marlin 2.0 with PlatformIO (on Anet Printer)
MKS TFT Firmware Upgrade & Customizing
Invert Stepper Motor Direction – 3D-Printing Basics
3D Printed Christmas Light Displays
Level Your 3D-Printer – 3D-Printing Basics
FLSUN Cube Initial Review – Large, Awesome but DANGEROUS!
Fix Layer Shifts
Get Started With Cura | Beginner's Guide | 3D Printing Tutorial
Flash Bootloader on 3d Printing Controller
Fix Noisy Fans on Your 3D Printer
Diagnose & Fix Z-Axis Issues on 3D-Printer
3d-Printing Vector Graphics - Tutorial
Christmas 2018 - Printing Last Minute Prints!
Create a Wearable Cubone Skull - Halloween 2018
Anycubic Utrabase on Anet A8 - Full Installation Guide
Dual Color Printing with a Single Extruder Machine
Simple Door Lock - 3D-Printing and Arduino Project
Channel Update June 2018, New Workshop, New Schedule
Anet A2+ Upgrades
JGAurora A5 Review - Good Printer for $350!
Anet A8 Dual Extrusion
Multi-Color Prints with Single-Color Printer
Filament Run-Out Sensor on Your 3d-Printer
Anycubic Kossel Upgrades
Anet A8 Controller Upgrade (Arduino Mega + Ramps)
Anet A8 - Heated Bed Insulation
Anet A2 (A2+) Initial Review
Anet A8 Marlin Firmware
![Let's 3D-Print Minecraft! [100 subs]](https://ricktube.ru/thumbnail/ktkemkvS_Gs/mqdefault.jpg)
Let's 3D-Print Minecraft! [100 subs]