Dr. Prashant Kushare

Construction of Structural Diagram: Machine tool gear box

Friction Clutches_ Part -I : Single Plate Clutch

GATE PAST YEARS QUESTIONS on SPUR GEARS _1 (Machine Design)

Friction Clutches (Discussion on Uniform Pressure Theory and Uniform Wear Theory)

Power Screws: Part-VI (Buckling Consideration)

Power Screws: Part-V (Problems on Power Screws)

Solved Problem on Design of Rigid Flange Coupling

Design of Hollow shaft

Solved Problem on Design of Cotter Joint

Problem on Design of Shaft (Solid shaft)

Worm Gear Drives: Friction ,Strength and Wear ratings of worm gears

Worm and Worm gears: Introduction and force analysis

Rolling Contact Bearings:Design for Cyclic loads and Reliability of Bearings

Rolling Contact Bearings: Static and Dynamic Load Carrying Capacity

Force Analysis of Gears (Spur, Helical and Bevel Gears)

Bevel Gears: Part-II (Beam Strength and Wear Strength)

Bevel Gears: Part-I

Solved Problem on Helical Gears

Helical Gear Design: Part-II (Beam Strength)

Solved Problem on Design of Spur Gear

Spur Gear Design: Part-IV (Wear Strength of Gear Tooth)

Design of Kennedy Key and Splines

Bearing Failures and Lubrication

Rolling Contact Bearings: Selection for Different Applications

Rolling Contact Bearings: Introduction

Case study: Taper Roller Bearing Selection from Manufactures Catalogue

Taper Roller Bearings: Selection from Manufactures Catalogue

Spur Gear Design: Part-III (Effective Tooth Load)

Spur Gear Design: Part-II (Lewis Form Factor)

Problems on Design of Levers ( Bell crank lever, Hand lever and Foot lever)