Nespresso Vertuo Next type GDV1 repair and full disassembly

This is a complete re-assembly of a Nespresso Vertuo Next coffee machine that I boldly took-it from a recycle bin (BestBuy :) ). At first tryout, the pod was spinning but no water was pumped, followed by some blinking error code. Initially I believed it was the water pump so I decided to completely disassembly, since it was quite dirty, coffee leaked on my clothing.
Often, because there is no cleaning cycle run for a long time, this machine will develop a clog in the draining tube ( the black silicone Y shaped tube inside), this causing the coffee waste to overflow inside the machine.
That is how I damaged my original machine, rinsing and cleaning the residues without covers disassembled. This was causing the water to go to the main PCB, that had no protective conformal coating to protect from water spill, an electrical short developed, the pod spin mechanism got destroyed.
This machine was looking like a perfect donor for the main PCB I needed, but finally I chose to completely clean-it and restore-it.
I trashed away the one with the damaged PCB and took care this time to fully cover all the internal, not protected, PCB from this machine with conformal coating, after this treatment, it should not be sensitive to any water spill.
Again, sorry for the quality or the speed, this was recorded as I was fixing-it so I did not pay too much attention to the video - it's as good as it gets!
This video is more about helping other adventurous DYI, trying to re-assembly or disassembly this unit, without breaking all the tabs and wires.
Good luck!