Subwoofer Plug and Play Harness - Audi B9/9.5 A/S4, A/S/RS 5, Q/SQ 5 - E1

In this video I’m going over the 3 different harnesses I have available to make a aftermarket subwoofer install easy in your Audi.

These harnesses will work for the following models AUDI B9 A/S4, B9 A/S/RS 5, MKII Q/SQ 5 AND B9 ALLROAD

If you wish to purchase one, please email me on the address below:

[email protected]

Also, here are all the products I used in my aftermarket subwoofer install on my 2019 RS 5. Some of these same item will work for other models.

Plug and Play Harness - https://tinyurl.com/4vtawdt5
Basser Box - Basser Box from Basser(https://tinyurl.com/3pcppmpj) or Basser Box On eBay(https://tinyurl.com/32rf5hsr)
JL Subwoofer - https://tinyurl.com/6j3q59az
Mounting Screws for JL Subwoofer - https://amzn.to/35dHHjh
Terminals for inside Basser Box - https://amzn.to/3r6eTBp
Kicker Key Amp - https://amzn.to/3bdlV2W
Bass Knob - https://amzn.to/3naG2kI
Right Angle Phono Wire for Bass Knob - https://amzn.to/3ngs7ts
Kicker Wiring Kit - https://amzn.to/2Xakqdw
Speaker Wire - https://amzn.to/3pRgBX7
RCA Cable - https://amzn.to/2XbO7Lp
Zip Ties - https://amzn.to/3rGsosC
Wire Taps - https://amzn.to/3qH7R5T
Felt Tape - https://amzn.to/3qHxAuT

Here is a Audizine post going over my install in detail.

https://www.audizine.com/forum/showth...

**MUST READ BELOW**

**Not all amps will work on a B&O system. If the amp can’t see 40v on the speaker input, your B&O amp will cut out because it will short to ground after a couple of start cycles. This is why I used the kicker amp linked above. The Kicker amp on high level input can see 40v and runs flawlessly. If you absolutely want to use a amp that can’t support 40v you can use a smart LCI linked here https://amzn.to/2OR6O69. If you have any questions you can DM me or ask below. **

Commissions Earned: As an Amazon Associate I earn from qualifying purchases.