Автор: The Odd Rod Garage
Загружено: 2023-06-25
Просмотров: 8575
We cut a C10 front crossmember to pancake it. This allows you to lay flame.
How to Section/Pancake and Tig Weld a C/10 Crossmember for the Ultimate DROP
LUCKY EP.7 | Step Notch Installation | Step-by-step guide on how to install the Velaworks Step Notch
Join me for a Thanksgiving drive, We are going back in time!!!
1963-66 Chevy C10 Front Suspension Swap to Square Body Front Suspension - #C10 #inliner EP.26
Опускаемся ниже: преображаем наш C10 1972 года с помощью системы Coil-Over от CPP — Project Harol...
МНОГО ПРОБЛЕМ, НО НАКОНЕЦ-ТО C50 ПОЛУЧИЛ БАМПЕР. LS1 заменили, C10 тоже хочет такой.
FRANCIS EP.4 | Комплект Velaworks Front Slam Kit своими руками | Установка карманов рычагов, верх...
Bailey Built S1E12 Front Suspention Assembly
AIR RIDE CROSSMEMBER | DIY Installation Guide for the GMSS C10 air ride crossmember.
Mounting 1955 -1959 Chevy/GMC truck on a C10 frame / E-Z Chassis Swap Kit / C10 Frame swap
Finishing the 1966 Chevy C10!
Laying Low, Rack & Pinion, and ZERO Bump-Steer!!
Frame is finished!
Mighty Max Ep. 04: How to Z Your Frame! Part 1
Truck Frame: Shortened, Pancaked, and Notched
RUSTY 60-66 C10 PICK UP, ROCKERS AND FENDER REPAIRS, 62 CHEVY TRUCK PROJECT 56
how to turn your 67-72 C10 long bed sides to short bed sides part 1
Did we make it to the HotWheels show?
Subframe raise on the C20 (pancake)
Chevy C10: бюджетный пикап, о котором вы даже не подозревали (Rustomod Reviews, выпуск 10)