9 step DiY Kitchen Range Hood Roof Flashing Install_ Roof Repair

All items used and the estimated cost are listed below and every step is time stamped for you to use as a guide. #KitchenRangeVent !

In this video, like our other videos, we are showing you step-by-step how to tackle a full roof repair project on your own without having to pay a roofing company and saving you hundreds of dollars. For this roof repair, an expected total cost from a reputable roofing company can cost anywhere from $250.00- $500.00. Here we will be installing a 6 inch Roof Jack for a #KitchenFan exhaust fan (Range Hood Vent) in most cases the same rules can apply for a 4-8 inch roof jack.
It's a very detailed jam packed video and by far, the best roofing how-to video out there. Below you will find a list of the items and tools needed to complete this roof repair.
Aurum Roofing is available online at: https://aurumroofing.com/

Total Expected Material List and Estimated Cost:
1 (one) Roof Jack Vent 6”
1-2 (one to two) tubes of roof sealant
1 (one) Asphalt shingle (if possible)
2 1- 1/4in metal screws
1 (one) 5lb box of 1-¼” roofing nails

Estimated Material Total: $50-$85.00
Estimated Total Cost for this type of Roof Repair from a Roofing Company: +$250-$500

Tools Needed:
Pencil, Hammer, Utility Knife with Hook Blade, Tape Measure, Flat bar, Recipitator Saw, Circular Saw, Caulk Gun, Roofing Nails,drill with proper drill bit. And as always, Safety First - Eye Protection and Gloves #diyroofing

Step # 1- 0:16 Go into attic and mark center.
Step # 2- 0:39 Locate center mark on roof and cut out a full circle from center mark with a 3.5” radius, make sure you cut SHINGLES only.
Step # 3- 1:04 Using your flat bar pull roofing nails from your work area.
Step # 4- 2:03 Cut full shingle circle into a half circle.
Step # 5- 2:29 Begin plywood cut (full circle).
Step # 6- 3:49 Install Roof Jack with metal seam side facing ground.
Step # 7- 4:58 Nail down Roof Jack
Step # 8- 5:57 Re-install the nails you pulled out from Step #2
Step # 9- 6:53 Apply seal over new and old nail holes

That's it guys and gals! You did it! You are all done with the roofing part of this small project. Now, go inside and work on your duct work. Again remember to like and subscribe for more roofing how to videos. See you on the next one!