Eaton Fuller Ultrashift Plus 10 Speed: Problem/Solved.
Автор: Lionsdejudah
Загружено: 2021-04-21
Просмотров: 100296
What’s going on in the Video: Air Brakes on, Foot Brake pressed for 2-3 secs and Released for 3-5 secs and Repeated.
The Initial Problem: Transmission to Engine Bell housing bolts came loose, opening up a 1/2” Gap on the very top and drivers side of the bell housing.
Missing Bolts were replaced and transmission & engine Remarried.
Transmission threw a Error code 27: Clutch Disengagement.
Truck will NOT go in drive/reverse.
Upon opening up the Inspection Hatch, 2 small springs(1/2” long .2 in diameter) and a broken up half moon shaped shim fell out, the radius of a 3” circle @ .125 wide and .050 thick.
Hypothesis: The ECA(electronic clutch actuator) may have been damaged or Something mechanical was damaged causing the Fault 27.
Problem is yet to be Determined.
...........................................................................................................................................................
!!! Problem Found/Solved: Clutch could not disengage.!!!
The little Springs(7 per plate) were from the 2 Clutch Plates, the 3” OD shim was what held the 21 splined center piece to the plate.
New CLUTCH was needed.
ECA was good.
FYI: Check your Bell Housing Bolts to make sure they have Not come Loose!
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
