Digital FPV Head Tracking Made Easy: Fully Removable All‑in‑One V1

Welcome back to Inverted Aviators RC! FPV head tracking made easy — check out my DIY V1 all‑in‑one removable system that fits seamlessly into multiple airplanes!

I built this compact marvel around a DJI O3 Air Unit, B.A.G. gimbal, Matek UBEC Duo, and 3D‑printed mounts—all cooled by a 40×40×10 mm fan and heatsink. Custom inserts, M2 screws, and minimal wiring make installation a breeze. My goal? A high‑quality, low‑cost head tracking solution you can swap between your fleet in seconds.

Affiliate Links:
Matek UBEC Duo: https://amzn.to/3TfF4pV
40x40x10mm fan: https://amzn.to/3TfF4pV
Heatsink (not exactly the same but close): 40x40x10mm fan: https://amzn.to/3TfF4pV
Screws for Air unit Mounting: https://amzn.to/3TQbAz2
M2 Screw Set: https://amzn.to/44dhQXS
Threaded Insert Set: https://amzn.to/44m2PBD
Double Sided Tape: https://amzn.to/3Fkcj8e
XT30 Connectors: https://amzn.to/4khzUW5
30 AWG wire I used: https://amzn.to/4dGngO1

Chapters:
0:00 - Intro
0:25 - Overview
0:54 - Goal
1:37 - Parts Overview
4:04 - Goals part 2
6:15 - Failures
8:21 - Future Plans
8:52 - Conclusion

📋 What you’ll see in this video:
– Full parts breakdown & 3D‑print files
– Simple wiring harness design
– Cooling performance under flight load
– On‑plane installation footage

👍 Like if you want more DIY FPV builds and hit subscribe for future V2 upgrades and installation guides.

#FPVTracking #DIYFPV #HeadTracking #DJIO3 #FPVBuild #3DPrinted #FPVSystem #DroneEngineering #FPVCommunity #FPVTutorial