Steel X gantry Workbee upgrade testing
Автор: Crabs Shed
Загружено: 2020-12-09
Просмотров: 2422
6061T6 6mm Aluminum, 1 flute, 5 EUR cheap carbide 3.175 mm (1/8") endmill. The sqaure being cut out is 40x40mm in size, inside circle has 35mm. No cutting fluid was harmed in the process, only air blast for better chip evacuation, and a tiny bit of cooling.
Spindle Kress FME 1050 P, speed 21000 RPM.
Ramping at 1000mm/s (39.4 IPM) down to 4.8mm (0.189") depth of cut, followed by an adaptive roughing at 0.38mm (0.015") width of cut at 3500 mm/min (137.8 IPM).
Then a very slow finishing pass follows at about 0:50 (0.2mm WOC at 600mm/s).
After that an outside roughing op with ramping, making 1.5mm (0.06") deep slots per pass at 1000 mm/s (39.4 IPM), again followed by a finishing pass.
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
