KWA HK45 Review

PLEASE READ!! I showed a KWA representative my video for a bit of consumer feedback, and he explained why certain measures were taken in the production of the HK45.
"A few comments. 1. 16mm barrel mimic real counter part. If you can't thread in properly. The problem is on the threading not because it's 16mm. 2. Markings on the gun is Umarex decision. not KWA. 3. 6.00mm marks on some pistols like PTP series is require for LE training use. 4. Plastic barrel decision is originally from M9 PTP firing test. When using a metal barrel, after 5k rounds the breech block tabs will break. The design carries over to later NS2 pistols. Engineering never consider to use metal barrel until ATP out in the market. 5. Slide HAS to be lighter weight to give optimal gas efficiency. So, unless you want a gun that's a wall hanger. Put in the after market parts so it will look good. Otherwise, keep it stock if you want to skirmish with it."
-KWA Allen
I later went back and researched it, and due to the wider tolerances of the 16mm suppressor, it DOES give the illusion that the threads are a bit harder to navigate. Upon further discussion with Allen, he said that the reason for going with plastic barrels was due to the old m9 PTP's breach block tabs breaking. This, from what I understand, isn't an issue in the HK45, however they remained with the plastic barrels simply for the NS2 system, so upgrading to a metal barrel won't cause damage over time.

ALSO, in regards to magazine compatibility. the USP MATCH magazine will work, although the base plate doesn't match. The standard USP magazine is slightly too short.

28 Round magazine Capacity, 2 mags per fill of green gas, 360fps, and confirmed kills at 90 feet. I'll take it.

If you are interested in buying the HK45, check out Middle Tennessee Airsoft Supply and use JORDANTV for a 10% discount on the items that I review! The link is below!
http://www.mtairsoft.com/ProductDetai...

Thanks for watching! Leave a like and Subscribe! Thanks again!