Built and Program your own 4*4*4 LED cube

To build a 4x4x4 LED cube, you must first solder 64 LEDs into four 4x4 layers, with each layer's positive terminals (anodes) connected, and all the negative terminals (cathodes) connected within columns. Then, connect these four layers together to form a cube by wiring the negative terminals of each corresponding column on each layer. Finally, program the cube by connecting it to an Arduino and writing code to control the individual LEDs by activating the correct layer and column pins.

In this Video I'll show you how to make a 4x4x4 LED cube using Arduino Uno. The cube has 64 Red LEDs which make up it's 4 layers and 16 columns. These are all wired to a Arduino Uno. An Arduino is a single-board microcontroller, intended to make the application of interactive objects or environments more accessible. The hardware consists of an open-source hardware board designed around an 8-bit Atmel AVR microcontroller, or a 32-bit Atmel ARM.
in this part i will focuse hardware part and in next part i will show you how to built code for 4x4x4 LED cube without any knowledge of coding. so we have software which will generate code automatically which you can just copy and past and enjoy Led cube animation.
*************FREE FREE FREE FREE,........I will be giving software Free of cost. just download and enjoy it
***************************************************************************
software link
https://drive.google.com/drive/folder...
*************************************************************************
Arduino IDE Software
https://www.arduino.cc/en/software
************************************************************************
Link for sample code
https://drive.google.com/drive/folder...
https://drive.google.com/drive/folder...

Underwater by Roa

/ roa_music1031
Creative Commons — Attribution 3.0 Unported — CC BY 3.0
Free Download / Stream: http://bit.ly/-underwater
Music promoted by Audio Library

• Underwater – Roa (No Copyright Music)
––––––––––––––––––––––––––––––
Special thanks to MARIUS for developing software