LaZouche Custom airsoft TM 1911-MEU sear and hammer fitment.

Ive uploaded this video upon various requests to show you in more detail how to locate the small springs and parts within the MEU/1911a1 inner frame. Its a tricky job to do and does seem to require three hands lol but with patience it can be done with ease.
I first show how to place the sear valve knocker spring, the sear shaft, the sear itself and the knocker valve actuater, then the rear sub frame that hold it all in place.
I then show you how to fit the small screw and not to over tighten it and to use thread lock to help keep it locked in.
As a secondary part I show how to fit the hammer, hammer shaft and then re-fit the rear sub frame section.
I also show how to fit the knocker valve actuater spring to the outside left of the inner frame. DO NOT LOOSE THIS SPRING!!! Yes you can get replacements but its a pain if you have to.

Should you need a replacement then go here:
http://www.eliteshootingcentre.co.uk/...

I usually keep a magnet handy so if the steel spring does fall to the floor or carpet then a quick sweep over it will locate it as it sticks to the magnet ;-)

I failed to say in the video but apply just a small amount of silicon grease or the thinner silicon oil to the internals upon re-assembly, just so it all runs smoothly.

Well I hope that explains it all alittle more clearly for you. Thanks for watching and if you have any questions please leave a comment or PM me.

Stay sharp and stay safe.