അമ്പല മെഷീൻ പെർഫെക്ട‌് സെറ്റിൽ ടൈമിംഗ്!!!

sewing machine shuttle timing adjustment
Adjusting a sewing machine's shuttle (hook) timing ensures the shuttle's hook point meets the needle at the exact moment required to catch the thread loop. Incorrect timing leads to skipped stitches, thread breakage, or needle damage.
Preparation and Diagnostic Test
Safety First: Unplug the machine.
Clear the Area: Remove the needle plate (switchplate), bobbin case, and presser foot. Ensure the needle is brand new and not bent.
Perform Timing Test: Use the handwheel to lower the needle to its lowest point. As the needle begins to rise, observe the shuttle. The hook point should cross the back of the needle just above the needle's eye.
Timing Adjustment Steps
Follow these steps if the test shows the hook is reaching the needle too early or too late:
Set Needle Bar Height:
Check for timing marks on the needle bar. If present, lower the needle bar to its lowest point and align the top mark with the bottom of the needle bar bushing.
If no marks exist, lower the needle fully and raise it roughly 3/32 of an inch (2.4mm). At this height, the needle eye should be about 3/32 of an inch below the hook point.
Adjust the Shuttle (Hook) Position:
Locate the gears or screws that hold the shuttle or the drive shaft in place (often found on the bottom of the machine).
Loosen the screws on the shuttle gear or the drive belt pulleys.
Rotate the shuttle manually until the hook point is positioned directly behind the needle, approximately 1mm to 2mm above the eye.
Set Horizontal Gap:
The gap between the needle and the shuttle hook should be very small: 0.05 mm to 0.1 mm (about the thickness of a piece of paper). If the hook is too far, it will miss the loop; if too close, it will hit the needle.
Finalize and Reassemble:
Tighten all screws securely.
Slowly turn the handwheel through several cycles to ensure no metal-on-metal contact occurs.