This 3D Printed RC F-22 Jet Is INSANE!

Is a 3D printed RC F-22 even any good? No. IT'S AMAZING! I'm blown away by these 3D printed RC Jets and how well they handle. This flight was a blast and I had a ton of fun assembling and building it too! #rcplane #3dprinting #f22

BUILD LIST!
Kyle's F-22 3D Print File - https://cults3d.com/en/3d-model/gadge...
Spektrum 4ch Receiver - https://tinyurl.com/5a83xktz
x2 40mm EDF's - https://amzn.to/4ieEd2H
x2 ESC's - https://amzn.to/4joHTQo
x2 Servos - https://amzn.to/3RfydMc
10mm magnets - https://amzn.to/3Ys0vH2
Servo Extension wires - https://amzn.to/3XHF5W0
ESC wire extension - https://amzn.to/4ikmzv7
Starbond Medium Glue - https://amzn.to/4hpM6Sn
Starbond Glue Accelerator - https://amzn.to/3DCqXGX
Bambu Lab Aero Filament (I'd suggest at least a couple rolls) -https://shrsl.com/4vx8f

Check out Bambu Lab 3D Printers!
X1C https://shrsl.com/4vx8b
A1 https://shrsl.com/4vx8c

Disclaimer: This description contains affiliate links. If you purchase through them, I may earn a small commission at no extra cost to you.

Timestamps
00:00 – Intro: 3D Printed F-22 Jet
00:15 – Filament & Printer Setup
00:43 – Electronics & Build Notes
01:00 – Maiden Flight Prep
01:42 – CG Check & Control Surfaces
02:23 – Hand Launch & First Impressions
02:48 – Flight Performance & Tuning
03:36 – Slow Pass & Full Throttle Test
04:15 – Loop Attempt & Elevator Adjustments
04:39 – Final Flight Thoughts
05:12 – Belly Landing Setup
05:56 – Successful Landing
06:04 – Post-Flight Recap & Encouragement
06:28 – Outro & Build Links