Lancer Tactical Gen 3 Evaluation and Modification

discord.gg/speedsoft
0:00 preview of the completed mod
0:08 testing cycle speed on different batteries
1:13 not so low fps spring
3:15 magazine fitment and feed test
6:57 The maker of the mosfet is a myth for all I care
7:28 programming basics
9:21 key point about the internals, basically an improved gen 2 etu, thats it
10:55 still photographs of the ETU
11:04 modification explanation
12:35 how easy it is to enable and disable binary
15:27 shooting after modification

all batteries were fully charged
Intro song is again, System Override by Makeup and Vanity Set
airsoftgi 14.8 binary    • WILL IT SURVIVE?!  - Lancer Tactical Gen 3...  

if you look closely the gen 3 etu says v2.3, the gen 2 board says v2.2, so its 100% an update of the old board

LT gen 3 notes
the externals are definitely gen2 tier which is pretty poop but it doesnt have the crunchy body that a combat machine does
I'll take this etu over the xasr in a edge because no contacts or cutoff lever
motor is chaoli whatever 24-26 tpa ferrous motor something
27 amps semi 10 on auto after mod

kinda torn on gen 3 or specna edge, LT is ETU with a better radiused gearbox, specna has better body and compression parts, hopup and barrel are essentially the same.

specna edge can take shs gears immediately, LT needs new etu or contacts to do so, unless you wanna drill a hole in a shs sector to put a magnet in it

The etu is definitely using active braking, I never double cycled on any battery before or after shortstroking even with lots of binary, which is incredible.

gears are more or less the same shit as specna edge, sintered steel mystery meat gears, does the job until they dont