SANDCRAFT DIY Installation - Carrier Bearing & Stock Driveline w/ Grease Whip - Polaris RZR XP Turbo

Full start to finish installation of a SANDCRAFT Carrier Bearing and Stock Driveline Combo with Grease Whip on a 2020 Polaris RZR XP Turbo. Check out the timestamps below to jump to a specific step and be sure to download the printable instructions PDF as well.

--------------------------

TIMESTAMPS

00:00 - Introduction
00:22 - Clutch Cover and Skid Plate Removal
00:47 - Transmission Flange Removal
01:19 - Scatter Guard and Sway Bar Link Removal
02:14 - Driveshaft Roll Pin Removal
02:53 - Driveshaft Removal
03:28 - Swapping OEM and SANDCRAFT Carrier Bearings
04:12 - Grease Zerk/Whip Hole and Explanation
04:30 - Scatter Guard Installation
04:55 - Carrier Bearing Base Plate Installation
06:47 - Driveshaft Installation
07:33 - Carrier Bearing Installation to Base Plate
08:19 - Roll Pin Bolt and Set Screw Installation
08:36 - Sway Bar Link, Skid Plate and Clutch Cover Installation
09:14 - Grease Whip Installation
10:13 - Conclusion

--------------------------

PRINTABLE INSTRUCTIONS

https://bit.ly/3je8qkD

--------------------------

REQUIRED TOOLS

• Paint Marker
• Button Removal Tool
• T-40 Torx
• Torque Wrench
• Ratchet Wrenches
• 8, 10, 13, 14, 15, 17mm sockets
• 13mm and 17mm Wrenches
• 4” Socket Extension
• 8” Socket Extension
• Socket Swivel
• Hammer and Punch
• Bearing Puller Tool

--------------------------

PRODUCT DESCRIPTIONS

SANDCRAFT Motorsports has once again raised the bar! With over 1 year of testing we are proud to announce the brand new GEN3 carrier bearing. We have created and patented this new design to be a GREASABLE bearing while having 3 layers of protection to keep dirt, sand, mud, and water out. Our all new auto set angle & 2 piece design will lower installation time dramatically. Auto set angle has never been easier. It allows you to press the bearing onto the shaft and install with minimal effort.

Side loading the bearing leads to pre-mature wear and failure. The auto set angle eliminates this from happening to your car. We are the ONLY COMPANY in the world with this design so don’t waste your time with the copycats.

SANDCRAFT Carrier Bearings allow you to service your bearing by adding grease through a fitting mounted to the housing. The grease whip inserts into the housing, allowing you to run the tube up through your center console so that you don’t have to crawl under your car to add grease. Who likes working underneath muddy, dirty cars? No one.

--------------------------

PURCHASE LINKS

Carrier Bearing with Grease Whip – https://bit.ly/30d1ygc

--------------------------

CONTACT AND SOCIAL LINKS

Check us out at http://www.SANDCRAFTMotorsports.com or call us at (480) 539-4438.
SANDCRAFT RCR Main Channel:    / sandcraft_rcr  
Instagram:   / sandcraft_rcr  
Facebook:   / sandcraftmotorsports  

--------------------------

#SANDCRAFTDIY #SANDCRAFTMotorsports #SANDCRAFTRCR