Installing carbon fiber straps on concrete block

This is a video of installing a product manufactured by Rhino. The carbon fiber straps were installed on 4' centers and 2' from corners. I ended up installing 16 straps total. I used Rhino straps in the critical areas and then found a cheaper carbon fiber strap supplier on from China for the remaining straps to save a couple hundred bucks. I used Rhino epoxy for all of the straps.

Disclaimer: I am not a licensed installer, and my installation methods are not in strict accordance to Rhino's installation instructions. Rhino has an installation video on youtube, link below:
   • Видео  

Consult a structural engineer for professional advice on the type of repair that is recommended for your application.

For the DIY'er, here is a list of stuff you'll need

TOOLS:
-DEWALT DWE46151 5" Grinder
DEWALT DW4777T 5-Inch XP Turbo Diamond Cup Wheel
-1-1/8" 10A SDS Variable Speed Rotary Hammer
-3/4" SDS Drill Bit
-Mastercraft Maximum 18V Drill/Driver
-Mastercraft Maximum 18V NiCad 3KO Impact Wrench
-Rhino Epoxy Gun
-Vacmaster VK811PH HEPA Vac 8Gal
-Scissors

SAFETY EQUIPMENT:
-3M Half Facepiece Reusable Respirator 7500
-3M 2091 P100 Particulate Filter (pair)
-3M 6001 Organic Vapor Cartridge (pair)
-DeWalt DPG82-11C Concealer Anti-Fog Goggles
-Hearing Protection


SUPPLIES:
-RHINO WALL REPAIR KIT RCF-8'
-Rhino Rhino Epoxy
-Rhino 600gsm CF straps, 5.2" wide x 8' long
-Carbon Steel Bracket, 3/16" thk, 1.25" x 8"
-Lag Bolts