Panda Prints! CR-10 / CR-10S - Adjust E-steps / Extruder calibration
Автор: Panda Props & Costumes
Загружено: 2018-06-25
Просмотров: 47177
Welcome to my new playlist, Panda Prints!
Today's video describes how to tune your e-steps / do an extruder calibration on your Creality CR-10 / CR-10S printer. I'me sure this could apply to other or similar models that use a Bowden tube to the hot end.
Nutshell: if your printer control box is trying to push out 100mm of filament, but only 50mm actually comes out - your prints are going to look awful. Tuning e-steps or calibration ensures that what amount of filament is being pushed out is ACTUALLY the amount being pushed out.
Most printers come from the factory without much fine tuning, so follow along with this process as it is a "must have" in order to achieve quality prints.
Thanks for subscribing!
Music: Crystal - by DJ AG
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
