Making a Coffee Grinder Box with Mitered Joints with Splines

In this view I make a box for a coffee grinder using mitered joints with splines for reinforcement. The coffee grinder was a kit from my local woodcraft (link below). I used cherry for the top and bottom of the box as well as spline and drawer face. Walnut was used to the side of the box, drawer, and drawer pull. I did use a small piece of plywood for the base of the drawer.

Time Stamps
0:00 Intro
0:21 Planing down the wood
0:53 Squaring up the board
1:15 Cutting the box sides
2:08 Cutting the top and bottom
2:28 Cutting the hole for the drawer
3:32 Glue ups
5:15 Drilling whole for the grinder
5:25 Cutting Splines
5:56 Gluing/Cutting Splines
6:29 Routing the round over around the top
6:38 Apply finish to the box
7:13 Cutting out the Drawer Face
7:19 Routing out the drawer base
7:38 The drawer pull
7:53 Glamor Shots

Coffee Grinder Kit
https://www.woodcraft.com/products/an...

Tools
Tablet Saw (updated version)
https://amzn.to/3z7Mmk8

Planer
https://amzn.to/34UgxgX

Router
https://amzn.to/3wXHkoq

Drill Press
https://amzn.to/3w4Yxwb