How To Program A Buick Envision Smart Key Remote Fob 2016 - 2020

A step by step video on how to program a smart key remote fob to a 2016 - 2020 Buick Envision.

More free DIY programming instructions available at https://www.ProgramYourRemote.com

1. Remove the key lock cylinder cap. Insert the vehicle key into the key lock cylinder on the driver door handle; then turn the key counterclockwise, to the unlock position five times within 10 seconds.The Driver Information Center(DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.

2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN, then press the ENGINE START/STOP button. (You may have to open and close drivers door to see the DIC display). The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.

3. Repeat Step 2 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. The DIC displays PRESS ENGINE START BUTTON TO LEARN, then press the ENGINE START/STOP button. (You may have to open and close drivers door to see the DIC display). Remaining remote key fobs can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1.

4. Place the new smart key fob in the cupholder .

5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next remote key fob.

6. Remove the transmitter from the transmitter pocket and press unlock on the transmitter.

To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.