Qolsys IQ Lock-PG: Setting Up on IQ4 Panel

In this video, Dylan from Alarm Grid shows you how to pair and use the Qolsys IQ Lock-PG with the Qolsys IQ Panel 4. Since this lock uses PowerG rather than Z-Wave, it has a potential range of thousands of feet from the main panel. This can solve the problem of being unable to automate the lock for a barn or an outbuilding.

00:00 - Introduction
01:50 - Check Panel Firmware
03:15 - Auto-Learn Mode
04:24 - Power Up Lock
05:00 - Configure Lock Settings
08:27 - Test Lock with Panel
09:33 - How to Reset Lock
10:01- Test Lock with App
10:54 - Give User Lock Access
12:06 - Test Code with Lock
13:15 - Outro

Physically install the lock following the instructions provided with it, or by following the steps outlined in our FAQ linked below. Once the lock is installed, wait to power it up until you're ready to pair it with the IQ Panel 4.

The panel must be on firmware version 4.4.0 or higher to support the IQ Lock-PG. You can check the version by tapping the gray bar at the top of the panel screen then tapping Settings, Advanced Settings, enter the Installer or Dealer Code (1111 or 2222 respectively, by default) then tapping About, then Software. If your panel is not up-to-date, you can check out the link the our FAQ (linked below) for instructions on how to update.

Once the panel is on a high enough version, to pair the lock tap the gray bar at the top of the panel screen, then Settings, Advanced Settings, enter the Installer or Dealer Code (provided above). Then tap Installation, then Devices, Automation, and finally Auto Learn Devices. The panel will begin listening for devices to auto-enroll. Now, power on the lock. It will go through the handing process (to determine whether it is on a right or left facing door) and will attempt to pair with the panel.

When the lock's DL ID pops up (you can verify it with the sticker on the lock itself) press "OK" then configure the lock settings. Dylan shows you all the settings in the video. One of the most important is the Pin Code. Usually, it's fine to leave this field blank. However, if you are pairing multiple IQ Lock-PG devices with the panel, you can note each lock's PIN (also located on the sticker with the DL ID) and enter that PIN as you program the lock. Just be careful when entering. If you make a mistake, it will appear that the lock has learned into the panel, but it will not work.

Once the lock is paired and configured, test it to be sure it's working with the panel. Then, you can log into the Alarm.com app and assign users access to the lock. Doing this will push the user's codes to the lock and allow them to manually unlock the lock using the push buttons on the lock itself when necessary. Once you access the user code, and give it lock access, wait for a sync to occur between Alarm.com and the panel. Once that's done, the code can be used at the lock.

https://www.alarmgrid.com/faq/how-do-...

http://alrm.gd/get-monitored