COM2000 PEUGEOT 307 PSA: Repair, Remove & Install Guide. MULTILINGUAL

If you want to listen to it in its original Spanish version, here’s the link to the video:    • COM2000 PEUGEOT 307 PSA MONTAJE/DESMONTAJE...  
Si lo quieres escuchar en español en su versión original, te dejo el enlace del video:    • COM2000 PEUGEOT 307 PSA MONTAJE/DESMONTAJE...  

This video shows the process of assembly and repair of the typical breakdown COM2000 dashboard-mounted vehicles of the PSA group (Peugeot, Citroen, Renault). In this case it is a Peugeot 307 2004. The failure is characterized by several symptoms that can occur simultaneously or in isolation any of the following:

Do not work lights, the horn does not work, not intermittent work, the previous work only occasionally, etc.

This ruling is very characteristic of a large number of times, and is due to dirt in one or more terminals plate COM2000 scorecard. The repair process involves removing the dashboard of the car, open the control panel up to remove the motherboard, clean dirty terminals that cause poor contact of the affected terminals, reassembling the motherboard, for by Finally, reinstall the dashboard COM200 in the car.

The video shows, once removed the dashboard of the car, as disassemble the dashboard to access the motherboard, such as cleaning the terminals, as reassembling the COM2000 and finally, how to install the dashboard COM2000 in the vehicle again.

If anyone were necessary to know the process of dismantling the vehicle COM2000, all you have to do is reverse the process shown in the video.

It is very important to perform the process described disconnecting the battery as a first step. To do this, you just have to disconnect the negative battery terminal, and this is shown at the end of the video.

NOTE: There are many the known faults COM2000 or other related lights, turn signals, horn vehicles PSA group elements, so it may be that even performing the process shown in this video, your particular problem is not It has been resolved. This video only shows how the assembly process COM2000 in the vehicle, and how terminals COM2000 plate cleaned, but at all is a guarantee that your problem is resolved. It will be solved only if the problem is due to the dirt of these terminals, which is what usually happens in many cases.

I hope this video will serve someone and help you solve your particular problem in your car as if this fault is made within the official home usually comes out pretty face.

Depending on the area, usually it costs between 200 and 400 € the new part (the COM2000) plus 100 or 150 other € labor, when in a couple of hours and a little patience can do it yourself with zero cost (what each value their free time into money).

#TENDENCIAS#RECOMENDACIONES#MOTOR#MECANICA
#TRENDS#RECOMMENDATIONS#ENGINE#MECHANICS