Eachine Razor - Build Overview

This is my build overview of the Eachine Razor. I'm going through my whole build process for this model, and highlighting any issues I find along the way. This is a fairly long video, so please feel free to use the chapters that I've added to navigate the video.

Firstly, sorry for the delay on this video. I was waiting on a motor to turn up, then two came along at once. Also, apologies for some of the shots. I currently don't have a lot of bench space, but will be working on that ASAP. I believe all the important parts were shown well.

Just to be transparent, the Razor kit was supplied by Banggood. The rest of the parts I bought myself. All parts are listed below. The opinions in this video are mine; and I'll be raising good and bad points along the way.

Contents
00:00 Introduction
00:54 The parts that I have chosen to use
03:26 The motor
08:30 Issue 1: The motor mount
11:19 Solution 1: What I did to get the motor to fit.
18:48 Fixing the hatch lid
19:27 Fitting the elevator servo
21:08 Points of interest regarding the elevator linkage. Watch out for binding
23:21 Fitting the aileron servos
25:55 Aileron throws
29:42 Disappointment: No CG markers
31:51 Issue 2: Balancing for CG
34:04 Setting the motor brake on the VGOOD ESC
36:00 Solution 2: What I did to try and help get the CG correct
39:03 Throws, rates, and the transmitter mix
41:09 The prop, I think I was lucky
42:07 Overview of changes
44:34 My final thoughts before the maiden flight

In this Video
Eachine Razor Kit https://bit.ly/MrD_2UrjxMt
FlashHobby 2822 2600KV motor https://bit.ly/MrD_3kwHSuP
SunnySky 2212 2450KV motor http://bit.ly/MrD_3aYAwz1
EMAX ES08A II Servos https://bit.ly/MrD_2H25FoX
EMAX ES08MA II Servo http://bit.ly/MrD_2IJ6VbT
FrSky RX6R Receiver http://bit.ly/MrD_2KGzAF3
FrSky Horus X10S Express transmitter https://bit.ly/MrD_3l7b8K5
VGOOD 30A ESC https://bit.ly/MrD_2H1LTdb This ESC is currently unavailable, but any 30A ESC with at least a 3A SBEC should be fine

Wire to connect to the small servo plugs https://bit.ly/MrD_3983DPz Buy a 1.25 female to 1.25 female

M3 Hex Bolt kit http://bit.ly/MrD_3o7QTx5 This is not the kit that I has in the video, but it does contain the M3 x 4mm bolts that I used for the motors.

If you found the video useful, I'd appreciate a thumbs up. This will help YouTube share this video with other RC pilots who may find it helpful. If you would like to get more videos when they become available, please subscribe and click the notifications bell icon. If there are links above, they may be affiliate links. If you click them, it will help me and my channel at no additional cost to you.

There are more tutorials on my web site at https://www.MrD-RC.com. You can also join like-minded people at the Fixed Wing RC Rebels group on Facebook. Also, if you found my videos useful, and would like to leave me a little tip, you could always buy me a Coffee at https://www.mrd-rc.com/go/ko-fi/

Thank you for your time, and don't forget to fly it like you stole it!