G0602 Project Pt 18 Steps per inch Axis Calibration

This is the 18th video in the series as I progress through my Grizzly G0602 CNC lathe Conversion. In this video I go through the procedure I use to Calibrate Mach 3 Turns units Per inch for the X and Z Ball Screws to determine if my calculations Accurate and check for any backlash. The procedure is a little different than it is for the Mill.

I will try to document and illustrate the process and hopefully put out information that others may have missed. Thanks for watching , Please subscribe, and feel free to comment,
Sam

In the next video I Start securing the X axis cabling and install the Home switches.
.
Disclaimer. I am not a professional. My videos are intended to
document my progress . I express no warranty as to the accuracy reliability or safety of the information provided here. By using any of the information provided in this video you acknowledge that I am not responsible or liable for injury or damage to property. Electricity is Dangerous proceed with caution follow all local regulations in your area. Visit the website at www.cnc4xr7.com