How to Recover Restore Optima AGM Battery | NOCO Genius Charger Review

1. Use a AGM-Specific Charger

‪@nocogeniusthailand9030‬

AMAZON AFFILIATE LINKS:
NOCO Genius Charage 10: https://amzn.to/3FAWuGp
NOCO Genius Charger 5: https://amzn.to/3FutIaB
NOCO Multiple Battery Charger [BEST]: https://amzn.to/4073e8y

Here’s the problem.

Most battery chargers have built-in safety features which prevent them from recharging deeply discharged batteries. If a traditional battery is at 10.5 volts or less, an analog charger will remain off because the battery is seen a defective. The charger will remain off because charging a “bad” battery could create an unsafe scenario. The AGM battery may be just fine, but has slipped below the minimum voltage threshold of the charger to turn on.

That’s why it’s important to purchase a modern, AGM-specific charger for your AGM-style battery.

AGM-specific battery chargers have special settings and desulfation steps that help recondition and recover deeply discharged AGM batteries. These are becoming more common, and they work well for all lead-acid batteries, too. They have the additional capability of doubling as a battery maintainer for batteries in storage. OPTIMA offers a Digital 1200 12V Performance Battery Charger and maintainer that enhances the performance of OPTIMA and other AGM batteries, recovers deeply discharged batteries, and extends battery life.

This is the preferred method of charging a deeply discharged battery.
2. Try the DIY Solution

Want to stick to the charger already in your garage?

OPTIMA offers an alternative that tricks your traditional charger into charging the deeply discharged AGM battery. According to OPTIMA, here’s what you need:

Battery charger (under 15 amps)
Jumper cables
A good battery, preferably above 12.2 volts. (It can be an AGM or flooded battery.)
The seemingly dead, deeply discharged AGM battery
A voltage meter
A watch or timer

Start by hooking up the good battery and deeply discharged AGM battery in parallel — positive to positive and negative to negative. Next, hook up the good battery to the charger and turn on the charger. The charger will “see” the voltage of the good battery (hooked up in parallel) and start providing a charge. After the batteries have been charging for an hour, check to see if the AGM battery is slightly warm or hot to the touch. Batteries naturally become warm during charging, but excessive heat may be an indication that there really is something wrong with the battery.

IMPORTANT: Discontinue charging immediately if the battery is hot to the touch or if you hear the battery “gassing” — a hissing sound coming from the safety valves.

With your voltage meter, check back often to see if the AGM battery has charged to 10.5 volts or above. This generally takes less than two hours with a 10-amp charger. Once it reaches the 10.5-volt threshold, disconnect the charger from the wall outlet and remove the good battery from the charger. Now, connect only the deeply discharged AGM battery to the charger. Turn on the charger and continue until the AGM battery reaches a full charge, or until the automatic charger completes the charge process.
SOURCE OPTIMA BATTERY

More About BundysGarage:
https://goo.gl/qv3Wzc

Questions, Comments, Concerns:
[email protected]

Twitter:
  / bundysgarage  
@bundysgarage

On The Web:
http://www.bundysgarage.com

Music by Randall Kent: As seen on NCIS
   • Randall Kent - Going Home (Featured on NCI...  

All Rights Reserved 2023
© Copyright 2023
Bundys Garage

All rights reserved. This material may not be published, broadcast, rewritten or redistributed in whole or part with out the express written permission. Contact: [email protected]

DISCLAIMER - DISCLAIMER - DISCLAIMER

Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not BundysGarage nor any of it’s subsidiaries.