How to Calibrate Z-offset: Ender 3/Pro/V2 + Touchscreen + FiRST LAYER Custom Firmware

A short video showing how to calibrate the Z-offset with the custom bundle from FiRST LAYER with a few tips. They have come out with a great firmware that is comparable to Jyers but works for the Ender Series Touchscreen. This will work on your Ender 3, Ender 3 Pro, and Ender 3 V2 if you are using the 4.2.7 board and Touchscreen. (Firmware used to come pre-installed on the mainboard, but they have now made it available on the google drive linked below.

If you have ideas for other short and to the point videos you’d like to see, let me know in the comments and I’ll try to make a video for it as soon as I get time.

The 4.2.7 Board and Touchscreen I recommend are these:

4.2.7 Mainboard:
https://amzn.to/3v91Ch3

The touchscreen I recommend is this one
https://amzn.to/3H8LoH1

I highly recommend installing fresh Creality Firmware, or if you feel like testing out another firmware, check out the F1rst Layer firmware. I love it and will likely not go back to Creality. F1rst Layer is a firmware close to Jyers, except it works with the ender series touchscreen.

Here is a link to the F1rst Layer firmware
https://drive.google.com/drive/folder...

If you liked this video and would like to support my Amazon Affiliate adventure where a small commission is kept when the link is used (no increase in price or anything like that for you), then use the link above.