Stihl MS200T Chainsaw Carb Idle Issue Fix - How To Remove, Clean & Refit A Zama C1Q S126 Carburettor
Автор: Marine Engine Servicing
Загружено: 2023-08-28
Просмотров: 2452
In this video, we have a look at cleaning a Stihl MS200T Zama C1Q S126 carb.
We see how to remove it from the saw, disassemble the carb and clean it.
Reassemble it and attached it back onto the saw.
Before Cleaning -
The saw had an idle issue were by it would start but stall, if you managed to get it revved up it would bog down then cut out.
The issue was that the carb / internal fuel pump was dirty and not allowing enough fuel into the engine.
TIMESTAMPS
00:00 Stihl MS200T Chainsaw - Zama C1Q Carb Removal, Clean & Refit
00:15 Removing back cover
01:38 Side cover removal
03:10 Linkage & hose removal
05:20 External carb body cleaning
06:25 Carb bottom cover removal
07:50 Carb lower section cleaning
10:00 Carb bottom cover reinstallation
11:30 Carb top cover removal
12:00 Diaphragm removal
14:40 Inlet control lever removal & cleaning
15:15 Carb upper section cleaning
15:31 Checking needle valve tip
16:50 Inlet control lever refitting
18:30 Top cover reinstallation
19:30 Refitting carb to saw
19:40 Throttle link refitted
19:55 Choke link refitted
21:00 Refitting fuel hose
21:55 Refitting back cover / air filter
22:55 Side cover refitted
23:50 Test run
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
