FANTOM | How to update 1.60 | Roland

Please, follow my Channel, I really appreciate your support!
WHAT YOU WILL NEED TO UPDATE

FANTOM-6 / FANTOM-7 / FANTOM-8
USB Memory
The USB Memory need to be formatted on a FANTOM-6 / FANTOM-7 / FANTOM-8.
GETTING THE UPDATE FILE
Please open/extract the downloaded "fantom678_sys_v160.zip" file on your computer to get the update file in the "fantom678_sys_v160" folder.
PROCEDURE FOR THE UPDATE
Caution
You must not rename the extracted files.
Never turn off the FANTOM-6 / FANTOM-7 / FANTOM-8's power while the update is in progress.
Creating the Update USB Memory
Copy all files inside the "fantom678_sys_v160" folder to the USB flash memory's root directory (the level displayed immediately after opening the device).

Update Procedure
Connect the USB Memory to the USB MEMORY port.
Hold down the [ WRITE ] button and turn on the power.
The message "preparing for update..." appears at the top of the display, and the initial update starts.
Continue to hold down the [ WRITE ] button until "preparing for update..." appears on the display.
The update operation takes about 2 minutes.
After confirming that the message "Update (board1) End..." has been displayed, detach the USB flash memory without turning off the power.
Do not turn off the power.
Connect the USB flash memory to any one of the EXT DEVICE jacks (1, 2, or 3).
The message "Running Update..." appears at the bottom of the display, and the update starts again.
The update requires about 5 minutes.
After confirming that the message "Update (board2) End..." has been displayed, turn off the power.
Detach the USB Memory from the FANTOM-6 / FANTOM-7 / FANTOM-8.

This completes the update operation. The new system program runs at the next startup.
Follow the procedure for verifying the version to verify that the version has been updated.