BMW N54 forward facing manifold install

All the parts I bought for this build:

3/4 heater hose for oil catch can 5 ft:
https://amzn.to/45TpEhx

1/4” hose for blow off valve : https://amzn.to/49WsUeB

3/8” vacuum / heater hose 10 ft:
https://amzn.to/4pIyJ40

Hose clamps: https://amzn.to/45l39Ca

Jackspania intake manifold: https://jackspaniaracing.shop/product...

N54 oil catch can: https://amzn.to/4sLW33B

Items I needed that you may need:
1/8” to 1/4” barb https://amzn.to/3YGA9RD

Motiv reflex plus: https://precisionraceworks.com/produc...

Upgraded fuel line from fuel tank to fuel rail: https://precisionraceworks.com/produc...

Fuel injectors for port injection: https://precisionraceworks.com/produc...

Fuel line for port injection: https://precisionraceworks.com/produc...

E85 harness reflex to ethanol content sensor: https://precisionraceworks.com/produc...

Motiv reflex data cable https://precisionraceworks.com/produc...

Port injection plugs if you choose to delete the port injection: https://precisionraceworks.com/produc...

Ethanol sensor ( I had one from my flex fuel kit)
https://precisionraceworks.com/produc...

Hobbs switch (used to command power to 2nd fuel pump at specified psi) : https://precisionraceworks.com/produc...

T map extension harness used to avoid cutting and extending the wires + converts to work with 3.5 bar map sensor: https://precisionraceworks.com/produc...

Heat shrink for extending throttle wiring harness and map wiring harness: https://amzn.to/4qyR5pw

Soldering station I used: https://amzn.to/49tQ389

To add port injection you should have a fuel pump upgrade, I have 2 walbro 450s, one is on a Hobbs switch, you may need able to use 1 525 walbro, I’m not sure, please do research on the fuel pump upgrades. You do need to upgrade the map sensor to a 3.5 bar map to run up to 35 psi or a 4 bar to run 43 psi.

3.5 bar map sensor: https://www.ecstuning.com/b-bremmen-p...

Choose you map as 3.5 bar in the mhd tune, motiv reflex for ethonol content analyzer.