How to Use Punch Down Tool? (Only 8 Steps)|Detailed Instruction|Step by Step| VCELINK

In this short video, you will be introduced to how to use Punch Down Tool properly. Only eight steps, but each step is detailed and clear.

Related products:
🔥VCELINK Punch Down Tool Kit
👉https://bit.ly/3XugYLe

🔥Cat6 keystone jack:
👉https://bit.ly/4ba4BaC

🔥Punch Down Tool:
👉https://bit.ly/3xrt0KY

🔥Punch Down Stand:
👉https://bit.ly/4b8pNO1

🔥Mini Wire Stripper:
👉https://bit.ly/4evrszZ


--------------------------------Steps-------------------------------------
1. Pull down the neck collar on the tool
2. Cut off the outer of the ethernet cable
3. Clean plastic strip
4. Separate wires and make them straight
5. Place wires in the right orders
6. Insert wires into the plug
7. Punch down the impact tool
8. Put a cap on the plug and then connect the plug to a wall plate
Done!!!!!!!!!!!!!

FOLLOW US:
👉Facebook:   / vcelinkofficial  
👉Ins:   / vcelink_official  
👉Twitter:   / vcelink  
👉TikTok:   / vcelinkofficial  

Check out our shop!
► https://www.vcelink.com
#punchdown #ethernetcable #rj45 #punchdowntool #diy #network #keystonejack #VCELINK

If you have any questions or concerns, please feel free to make a comment below!
If you think it's a helpful tutorial, please LIKE and SUBSCRIBE to us!
😍Thanks for watching, see you next time!

▼What else is Worth Watching?▼
How to Install CAT6 pass-through connector？
   • How to Install CAT6 pass through connector...  

How to Use Punch Down Tool?
   • How to Use Punch Down Tool? (Only 8 Steps)...  

How To Terminate CAT 7 Category Cables？
   • How To Terminate CAT 7 Ethernet Cables - E...  

The Most Detailed Brush Wall Plate Installation Tutorial |VCELINK
   • The Most Detailed Brush Wall Plate Install...  

How to Punch Down an RJ45 Cat6 Keystone Jack VCELINK?
   • How to Punch Down a RJ45 Cat6 Keystone Jac...