How To Commission a Fireray 5000 Beam Detector

The Fireray® 5000 motorised reflective, auto aligning infra-red beam
smoke detector can be installed with up to two detector heads per
system, thus saving on installation time and costs. In addition, each
system controller houses two pairs of fire and fault relays, one per
detector.

This innovative system has been designed from the ground up
to include pioneering technology that fully addresses the needs of the
installer and user, both now and in the future.

With its industry leading optics, the Fireray® 5000 is ideally suited for
the protection of large areas where the use of traditional detection
technologies would prove to be too difficult and/or costly to install.

The Fireray® 5000 combines an infra-red transmitter and receiver in the
same discrete unit and operates by projecting a well-defined beam to
a reflective prism, which returns the beam to the receiver for analysis.
Smoke in the beam path causes a drop in power, which, if below a
pre-determined level, results in an alarm signal.

Features
• Allows for 2 Detectors per System Controller
• Each Detector configurable from 8m to 100m
• Separate Fire and Fault relays per Detector
• Integral LASER alignment
• Auto-Align Fast Automatic Beam Alignment
• Contamination Compensation
• Low Level System Controller
• Logs the 50 most recent events per Detector
• Programmable Sensitivity and Fire Thresholds
• 20mm Cable Gland Knockouts on System Controller
• 2-wire interface from System Controller to Detector
• Working Optical path for Detector Alignment

Shop the FFE Auto-Aligning Optical Beam Smoke Detector at ADI | https://bit.ly/3JcGtZh

Visit ADI | https://bit.ly/3vqdpK2

#adi #adidifference #breamsmokedetector #smokedetector #ffe #firefightingenterprises #Fireray #Fireray5000