Micronics SLS nylon 3D printer makes electronic circuits

A new desktop SLS nylon 3D printer can make printed electronic circuits with the addition of a powdered catalyst and electroless copper plating bath. The printer is available here: https://www.kickstarter.com/projects/...

Applied Science video on SLA printed circuits:    • Make plastic printed circuits with a stand...  

Favorite copper plating bath recipe:
Heat 250ml deionized water to 60*C in a 300ml beaker, stirring at 350 RPM
Add 2.5g CuSO4*5H2O, wait until dissolved
Add 4.6g EDTA disodium dihydrate, wait until dissolved
Add 0.84ml of 1% Triton-X 100 solution in water
Dissolve 5.8g NaOH in 30ml DI water, stir until clear, then add to bath
Add 4ml Formaldehyde (37% HCHO)
Lower stirring to 100 RPM and begin filtration with 0.5 micron syringe filter and peristaltic pump. No intentional oxygenation or bubbling. Filter return is below surface for minimal splashing.


I experimented a little with PEG and 2 2' Bipyridine, but didn't find them impactful enough to discuss in this video.

LED rectenna designs:
https://josepheoff.github.io/posts/1-...
https://www.nrl.navy.mil/STEM/LEctenn...

Electroless copper references:
https://www.nmfrc.org/pdf/p0295g.pdf

Copper chromite catalyst:
https://www.sigmaaldrich.com/US/en/pr...
Possibly available here: https://www.kremer-pigmente.com/en/sh... It's been backordered for a month, so I wasn't able to test it.


Open Sauce 2024:
https://opensauce.com/


Support Applied Science on Patreon:
  / appliedscience