How to Reset TacticalFlowMeter Clamp On Ultrasonic Flow Meter

Call 831-244-8080 for questions

We show How to Reset TacticalFlowMeter Clamp On Ultrasonic Flow Meter

This should RARELY be necessary and is useful if you have discovered a user mistakenly adjusted some parameters.

These are also called Ultrasonic Transit Time flowmeters and clamp on flow meters.

These are commonly used as Ultrasonic flow meters for water and they are low cost compared to meters that require cutting into the pipe.

The MAJOR BENEFIT is you can clamp these on the outside of your existing pipe without any penetrations.

Tactical Flow Meter Ultrasonic Flow meters features LARGE LCD display, shows the Instantaneous Flow Rate, Total Flow, in user selectable units.

Specifications
Medium: Any acoustically conductive fluid with less than 5% air bubbles or solids
Pipe size: ¼” to 240”
Flow rate: 0 - 200 GPM, guessing….
Temperature: - 20 - 110 ℃
Transducer material: Aluminum and 304 SS
Cable length: 8’ to 20' nominally
Accuracy: ±1% from 0.15 to 40 f/s (0.05 to 12 m/s)
Resolution: 0.01 ft/s (0.00025 m/s)
Response time: 150 ms measuring cycle typical
Transducer Frequency: 1 MHz
Clamp-on transducers: encapsulated design IP68
Enclosure Protection Grade: IP65
Display LCD Screen
Power Supply: 24VDC or 86-240 VAC Universal Power Supply
Output: 4-20mA + 0-10K Hz + Standard ModBus RTU Communication protocol
Note: For 1 to 5 VDC output, add 250 Ohm resistor to 4 to 20 mA loop.

View full spec sheet here.
https://www.tacticalflowmeter.com/pro...
Please like this video and subscribe to our channel if this video helped you.