Polaris XLT Install Heated Grips, Kill Switch Tether & Delete Throttle Safety Switches

1:02 Remove old grips
1:59 Explanation of installing heated grip pads
3:10 Remove throttle block to get to the wires needed for the heated grips
9:47 Remove Delete Throttle Safety Switches
11:23 Cutting the Throttle Safety Switches Off
14:24 Install Heated Hand Grip Pads
18:48 Solder Heated Hand Grips On
One black wire (on heated grip) solder to two blue wires (on the sled) (this method makes the High and Low Switch on the Sled Produce High heat)
The other black wire (on heated grip) solder to the brown wire (on the sled)
22:05 Stick Heated Hand Grip On the Bar
24:08 Install New Rubber Grips on Over the Heated Pads
24:30 Use Air Compressor to Get New Rubber Grips On (You can also use this method for removal)
25:30 Install Kill Switch Tether
30:41 Explanation of Wiring the Kill Switch Tether
Red (kill switch hot wire) to Black (on the sled)
Green (kill switch ground wire) to Black (on the sled)
32:55 Test New Heated Grips & Kill Switch Tether

I've had zero issues or problems since deleting my throttle safety switches. I always ride with the tether if I'm going high speed and worried about the sled getting away from me with the throttle stuck open

View my other 1995 Polaris Indy 600 XLT videos:
   • 1995 Polaris Indy 600 XLT