Socomec ATyS P Changing Timer Value

This video shows step by step guidance to assess and change timer values for ATyS P range Socomec changeover switch. Example used in video is changing 1RT timer (Primary Source availability/stabilisation timer/source 1 return timer). This video is useful if any application requires modification of built-in timer values to suit a specific application.
For detailed information on programming ATyS P changeover switch please refer to the full manual available at: https://bit.ly/2W67uF4

Note: This video is aimed at competent persons. Always refer to the original documentation when installing/commissioning. Under no circumstances shall NHP be responsible or liable in any way for any content, including but not limited to errors or omissions in the content, or for any loss or damage of any kind as a result of any content communicated in this video by NHP.

In no event shall NHP be liable for special, indirect, or consequential damages or any damages whatsoever resulting from the loss of use, data or profits arising out of or in connection with the availability, use of performance of any information communicated in this video. Due to factors beyond the control of NHP, it cannot guarantee against improper use or unauthorized modifications of this information.

NHP assumes no liability for property damage, or injury incurred as a result of any of the information contained in this video.

Use this information at your own risk. NHP products are for professional use only and NHP recommends safe practices as such, please consult a professional for any procedures or tools seen or implied in this video.

Due to factors beyond the control of NHP, no information contained in this video shall create any express or implied warranty or guarantee of a particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not NHP.