How to really effectively mesh level your bed with jyers firmware

Hello everyone: I go into real detail about mesh leveling your Ender 3 V2.1 3D printer. In this video I make three attempts before i really get the printer to print properly with Silky Copper PLA from Eyrone. I don't know if you have to be as accurate with regular PLA, but it took me three tries before I really got the bed mesh leveled and printing good. The key here is a good print without any support or adhesive whatsoever, and by washing the glass bed really good with soap and water. This video is one hour long because I just left the camera running while the prints were almost perfect.

The key to a successful print is in using as thin a piece of printer paper as possible, AND making sure that the printer paper as close to the nozzle and bed as possible without totally being unmovable, I mean just until it has lots of friction moving in the gap between the nozzle and the bed.

In this video you will see the first attempt having 3 out of 4 Nintendo 64 joystick adapters being started off as perfect but the third one lifting , the second attempt the alignment is to far out for any of these adapters to print out the base properly , but on the third attempt the adapters get printed out perfectly.

I would like to thank all of you who have made it as far as the end of the video, without you, making videos would not be as fun.
Russ Campbell