How To Set Up and Bind Vortex 250 Pro with RadioLink AT9 (S.Bus)

In this video, I am going to show you how to bind and completely setup your ImmersionRC Vortex 250 Pro quadcopter with the RadioLink AT9 using S.Bus.

This works with the Vortex 285 too.

Steps:
0) REMOVE ALL propellers!!!
1) Remove top plate from Vortex
2) MOUNT the VTX antenna!!! - don't want to burn out the transmitter...
3) Use provided S.Bus cable and plug into your AT9 transmitter
4) Plug in the battery and power on system
5) Turn on RadioLink transmitter and ensure it has bounded to the R9D receiver
6) Turn on your FPV monitor or goggles and tune to default 5740 MHz (Fat Shark 1) channel to see OSD
7) Wait for the Vortex flight controller to detect the receiver
8) On RadioLink transmitter ensure your model is on Aircraft...you must then reverse the throttle and elevator (left and right stick up and down) channels
9) Follow Vortex OSD setup
10) Setup Failsafe - very important!
11) Assemble quad back together and enjoy flying now
12) Profit!!

RadioLink Settings I use (modified Storm Racing Drone settings):
https://drive.google.com/open?id=0Bwd...

**Note that Switch G controls the 3 different flight modes. You adjust the flight mode switch under AUX-CH to a different switch here.

R9D Receiver converted to micro sized:
https://drive.google.com/open?id=0Bwd...

Flight test:
   • Maiden Flight Test Vortex 250 Pro with Rad...  

Any questions or comments, please post them below and happy and safe flying!


Ending soundtrack:
Dance of the Pixies by Jens Kiilstofte
https://machinimasound.com/music/danc...
Licensed under Creative Commons Attribution 4.0 International
(http://creativecommons.org/licenses/b...)