Summa S One Cutter Unboxing & Build (Peaceful Assembly Guide)

See more detailed assembly instructions below ⬇️ ⬇️ ⬇️

Whether you’re installing your first Summa cutter or you simply enjoy precision-made hardware being assembled, this video is both instructional and oddly calming. This video was created to be both peaceful to watch and useful to follow, showing how to assemble a Summa S One cutter from box to finished machine.

Learn more about the S One Cutter here: https://www.digiprint-supplies.com/en...

INSTRUCTIONS:

*Download full instructional PDF here: https://info.digiprint-supplies.com/h...

Unpacking the Cutter

Lift the cutter from the box and place it on a table.

Among the parts, there is an accessory kit located separately, glued to the inside of the cutter box. This kit includes many accessories and a printed assembly guide.

Assembling the Stand

Locate all eight M5 by 18-millimeter screws and place a lock washer on each one.

Carefully thread two of the screws into each of the horizontal panels.

NOTE: Because you are driving steel screws into threaded aluminum, we strongly recommend hand-tightening as much as possible to avoid cross-threading the screws.

Tighten each screw 7-8 full turns.

Remove the plastic covers from the legs and put them aside.

Carefully thread one of the M5 x 18 screws into each of the four remaining threaded holes in the horizontal panel. Tighten approximately 8 turns.

Hold the horizontal panel with... (Download our free PDF using the link above.)

#Summa #PlottingCutter #DIGIPRINT