How I pull an FRS/BRZ/GT86 Transmission in 20 mins!

**************Tools used, in the description below*****************

Decided to video a typical throwout bearing/clutch replacement pull. The whole job can take anywhere from 1-4 hours depending on your skill level and tool availability. I have pulled hundreds of transmissions, don't expect your first one to come out this quickly.

Tools Used (not all necessary):
1/4 Drive Snap-On Ratchet
1/4 Drive Snap-On 10mm Socket(for battery terminal, 10mm box wrench does the trick)
3/8 Drive Snap-On Flex Head Ratchet
3/8 Drive Snap-On 3" Wobbleplus Extension
3/8 Drive Snap-On 14mm Socket
3/8 Drive Snap-On Electronic 14v Cordless Impact
3/8 Drive Snap-On 10mm Impact Deep Socket
3/8 Drive Snap-On 12mm Impact Deep Socket
3/8 Drive Snap-On 14mm Impact Deep Socket
Snap-On 14mm Open End Wrench
Snap-On 12mm Open End Wrench
Pittsburg 14/12mm 12 point slanted end wrench(used on the driveshaft bolts)
Gear Wrench 14mm Ratcheting Box Wrench
Snap-On 2ft Braker Bar
Snap-On Hose Tool
Snap-On Long Clip Tool
Mac Push Pin Pliers
1/2 Drive Pittsburg 30mm 12 point socket(for putting in back of trans)
1/2-3/8 Snap-On Conversion (used to plug the 30mm socket)
1 Can of PB Blaster
Harbor Freight Pogo Jack
Harbor Freight Transmission Jack


Disclaimer
It doesn't always go this easy. Even with this car, from a new unfamiliar customer, I had to deal with bolts that usually take 10 seconds to remove, and they ended up taking 5 mins, because someone installed the front pipe incorrectly. The dowel pins on the block were also slightly seized, but nothing too bad. Attempt at your own leisure.