This scrap build helps protect my lungs! DIY Solder Smoke Absorber
Автор: DMS Creates
Загружено: 2025-08-05
Просмотров: 217
I'm getting into larger soldering projects and realized it's about time I start protecting my lungs, so I figured I'd create a little smoke absorber to run while I solder.
Note: This is by no means enough if you're doing a lot of soldering, but for the occasional solder job, this is good enough. Always solder in a well-ventilated space and (if possible) vent fumes out an open window or through a proper filtration system.
======================
Contents
0:00 - Intro
0:15 - Parts list
0:36 - Case preparation
0:53 - Fan hack
1:17 - Switch wiring
1:35 - Wiring Diagram
1:40 - Soldering
1:55 - Fan switch test
1:45 - Heat shrinking
2:25 - Hot glue as heat shrink
2:34 - Assembly
2:56 - Testing w/ Filter
3:20 - Switch case and glue
3:49 - Gluing the Barrel Jack
3:59 - Final Switch location and cable management
4:26 - Final Test
======================
Links
3D Model for Case: https://www.thingiverse.com/thing:275...
======================
Necessary items for this project (Affiliate links where applicable):
12V 120mm fan
12V power supply I had lying around
barrel jack with screw terminals
A SPST switch
3D printed case
Activated charcoal filter
Solder supplies: solder, wire, flux
Hot glue
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
