Centurion D6 Smart Gearbox worm gear & main drive gear support system & manual release mechanism

Centurion systems has released the new Centurion Smart sliding gate motor systems.
One such sliding gate motor is the newly rebranded Centurion D6 sliding gate motor.
The Centurion D6 Smart sliding gate motor is a 24 volt dc system, which can be upgraded to a power pack system.
The Centurion D6 Smart can run steel sliding gates up to 600kg in weight and up to 36 meters per minute.
Centurion systems, claims a 200 000 life cycle.
The Centurion D6 Smart sliding gate motor has an all steel gearbox system, which is only supported with 3x steel bearings.
The worm shaft is supported with a open ended bearing on the bottom section which lies in a pool of oil. The top worm shaft bearing is a sealed bearing which is filled with grease from the factory.
The main drive gear shaft is only supported with 1x open ended bearing between the main gear and the gate motor pinion gear.
a plastic holder supports the main drive shaft on the other side.
This plastic holder can wear out prematurely if the gate motor installation is poorly effected and not maintained.
This means that the installation should be maintained on a yearly basis by a professional Centurion gate motor installer like Pottie.
for more information, look here:
https://smartgates.co.za/centurion-sm...

for older centurion gate motors, look here:
https://smartgates.co.za/installation...

for other information look here:
https://www.exquisitesecurity.co.za/i...