I built this guitar ENTIRELY out of a single pallet. Watch Full build in 25 minutes!

I built this guitar out of a pallet I got for free. The pallet was over 7ft long and I had to cut it into three pieces to get it to fit in my van. It's all White Oak other than some pine for the bracing. It was fun!

Since some of you are asking, here are some of the inexpensive tools I use for guitars. I do this for fun and I am not wealthy so I try to find the cheapest way to keep the hobby going. I hope this list shows that you can get started without spending all your money!

Heating pad for side bending - https://amzn.to/3YaHyHV
Epoxy I used: https://amzn.to/46Z2fe3
Black pigment to tint epoxy: https://amzn.to/3TbI2w3
Fret Saw - https://amzn.to/3yHA8mT
Rabbet Bits for cutting binding channels -https://amzn.to/3yFwfPw
Feather Board - https://amzn.to/3XdRktE
Plastic Binding - https://amzn.to/3AAK1mU
Circle Jig for cutting rosette - https://amzn.to/3E3sXba
Pre Cut Fret wire - https://amzn.to/4dJ9gSv
Not pre cut fret wire - https://amzn.to/4dGixLD
Fretboard Radius Sanding block - https://amzn.to/3WR7B6i
Brass hammer for frets - https://amzn.to/4dPvvX3
Fret Crowning file - https://amzn.to/3yH4u96
The worlds cheapest spoke shave - https://amzn.to/4fKkfwP
Shinto Rasp - https://amzn.to/46NtPuG
Block Plane - https://amzn.to/4fYJrzz