Triple Loop Bangle made with Curved Tube Beads

Some people including myself, have had trouble making a multiple loop memory wire bangle with curved tube beads. This video will show you how to make an average to large triple or larger curved tube memory wire bangle. Here is a written synopsis.......To make a triple, (quadruple or even larger) loop memory wire bangle with curved tube beads.
I found using a 2.25 inch diameter memory wire to be best for an average to large bangle and have it sit just right, with plenty of room to spin.
I measured the top of the bracelet (how many inches to place my beads) and came up with 1.75 inches.
Each side of each loop will be your curved tube beads, (I use 38X2mm curved tube beads).
And on this bracelet I used 3 inches of beads for the bottom.
So when starting the beginning, and on the last end, I used 1.5 inches of beads, which when finished
results in the two ends adding up to the 3 inches. Here the two charms will dangle next to each other.

I tried this with three sizes of beads, the first was made with size 6 seed beads, then I made one with 4mm czech and 4mm swarovski bicones, and the third was made with 6mm round pearls and 4mm daisy spacers and all three bracelets sit very nicely and evenly on your wrist.

The 2.5 inch diameter memory wire seems perfect for multiple loop bangles, and still is not so big that if would slide over your hand. Unless of course you are very tiny, or trying a child size, in which case the dynamics would change completely. Probably (I haven't made one yet) using a smaller diameter memory wire and smaller tube beads. I will have to make one and post once I do, the sizes needed.