Part 4. Making Internal Combustion Engine, No Machine Shop - Cutting and Soldering the Cylinder
Автор: Makerj101
Загружено: 2015-11-02
Просмотров: 325044
Building the cylinder out of 3/4 inch copper pipe and other copper sheet scrapes. And don't forget the solder... lots and lots of solder. Silver solder is recommended because it has a higher strength. I do not however recommend brazing. Brazing will remove the annealing from the copper and will make it very soft. Possibly too soft. That's just my opinion though. Plus I don't have brazing equipment. I am thinking this could also be done with JB Weld and epoxy putty. You would just need to use a lot to make sure it's strong enough as JB Weld has about half the tensile strength of the solder I used.
If you have not already watched, here is part 1:
• Part 1. First Attempt at Making an Interna...
And part 2:
• Part 2. Making Internal Combustion Engine,...
Part 3, casting epoxy piston:
• Part 3. Making Internal Combustion Engine,...
Part 5 is here! • Part 5. Making Internal Combustion Engine,...
Keep exploramenting and thank you for watching! Don't forget to subscribe for more! http://www.youtube.com/user/makerj101...
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
