Engraving 101. Quick 7 minute video. How to engrave metal for beginners

Metal engraving from start to finish. Took a 2 hour video and condensed it into 7 minutes. Hope it doesn't skip through too many parts. If you have inquiry please email me: e3engraving@gmail. Located in Las Vegas and available to ship. Please see my IG @E3_engraving.
I provide links for purchase, these are not my products.
Check the below links for purchases, I researched the best prices for the quality.
Both Ebay and Amazon!
--Pneumatic Engraver machine:
There are many variations of this machine and prior it was priced at $900. With replicas and new machines the price has dropped. I recommend this machine as it is the main one I use, as well as my staff. We have higher priced units, and lower, but this is the one that sets the standard. This unit also includes the hand pieces to install the square gravers.
Ebay:
https://rover.ebay.com/rover/1/711-53...
Amazon:
https://amzn.to/2JWM2xh
--Ball Vise
I recommend a ball vise that doesn’t slide easily. There are vises with tabs which make the engraving harder to hold steady, especially for someone new to engraving.
Ebay:
https://rover.ebay.com/rover/1/711-53...

Amazon:
https://amzn.to/2JWw9ql
--Silent air compressor
I recommend you purchase a silent air compressor, they are appropriately priced and work with the engraver recommended perfectly. This is a silent air compressor and doesn't take much room.
Ebay:
https://rover.ebay.com/rover/1/711-53...
Amazon:
https://amzn.to/2LGjEBr

Graver blades 3/32” x 3/32”
These blades are pre-sharpened so you can get right to cutting.
Only available through Ebay:
https://rover.ebay.com/rover/1/711-53...