Increment Bed Heating in Cura | Fix for Ender Extender 400 with stock bed heater
Автор: Lucas Builds Stuff
Загружено: 2021-03-07
Просмотров: 3858
In this video I show how you can use Cura to increment the bed heater in order to allow for better heat distribution on the Ender Extender kit with a stock bed heater.
The 2 main problems I ran into with the stock bed heater on the Ender Extender 400xl were:
PETG 85C - the thermal run away alarm would trigger and shut the printer down
PLA 60C - on larger prints the corners would lift
Both problems were caused by the large heat bed acting as a heat sink and not allowing for proper heating.
In this video I am using an Ender 3 with an Ender Extender 400XL Kit. I've had the kit for over a year and love it! If you are looking to purchase one, I have affiliate links below, thank you.
GCODE: https://lucasbuildsstuff.com/blogs/ti...
CHEP's video on Cura Start Gcode: • Faster Hot End & Heated Bed warm-up in Cura
3d Printer Tuning Guide by Teaching Tech: https://teachingtechyt.github.io/cali...
Affiliate Links:
PETG: https://amzn.to/3KtE3pY
PLA: https://amzn.to/3OI4F9o
Ender Extender Kit: https://enderextender.com/collections...
Доступные форматы для скачивания:
Скачать видео mp4
-
Информация по загрузке:
